AutoCodes
 
OBDII Code List
 
U1009 MERCURY

U1009 MERCURY - SCP Invalid or Missing Data for Engine Torque

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

U1009 MERCURY Possible Causes

  • Faulty / intermittent ignition module
  • J1850 / SCP Bus wiring intermittently open, shorted to power or ground
  • Faulty / intermittent connection at the Powertrain Control Module (PCM)
  • Faulty EGR Sensor

First diagnose U1009 MERCURY code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

U1009 MERCURY Tech Notes

This is typically an electrical wiring connection issue, either at the engine controller or at the sensors being monitored by the manufacturer.
It can occur if:
The wrong EGR sensor is installed on the vehicle. Verify with the manufacturer for the latest.
A bad ignition module is present.

Cost of diagnosing the U1009 MERCURY code

    Labor: 1.0

    The cost of diagnosing the U1009 MERCURY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the U1009 MERCURY code detected?

When the PCM is unable to communicate with any other controller on the bus network at any time while the ignition switch is in the “Run” position.

U1009 MERCURY Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Check Trac Light / ABS Light On
  • Bucks at highway speeds

U1009 Mercury Description

This is a manufacturer specific fault code and can be used for several different faults, depending upon what the manufacturer wants to use it for. The Powertrain Control Module (PCM) communicates over the Serial Communication Protocol (SCP) bus network, or J1850 bus. This is a medium-speed bus communication system and is fault tolerant, which means any type of intermittent/loose connection at these controllers will cause this code to set in memory, but will still operate, provided a data path is available. When the PCM is unable to communicate with any other controller at any time while the ignition switch is turned on, code U1009 will set. This is the typical reason for this code to set.
OBDII Code U1009 Mercury - SCP Invalid or Missing Data for Engine Torque - AutoCodes.com

U1009 MERCURY More Information

Need more information on how to fix the U1009 MERCURY code?
Get Access to Factory Service Manuals

Need more help?

Get the U1009 Mercury code diagnosed by a professional: Find a repair shop in your area

Related Information

U1009 MERCURY Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the U1009 Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧