AutoCodes - OBDII Code List - U1001 2010 NISSAN VERSA

U1001 2010 NISSAN VERSA - Invalid or Missing Data for Primary Id

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

U1001 2010 NISSAN VERSA Possible Causes

  • Controller Area Network (CAN) communication harness is open or shorted
  • Faulty Engine Control Module (ECM)
  • Poor harness ground connection.

How do I fix code U1001 2010 NISSAN VERSA?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

Nissan has released service bulletins for this problem see U1000 code. A common cause with Nissan vehicles is the poor harness ground connection at the engine compartment and the ground connection behind the dash. Clean and resecure harness ground connection and reset engine light.

Cost of diagnosing the U1001 2010 NISSAN VERSA code

Labor: 1.0

The cost of diagnosing the U1001 2010 NISSAN VERSA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

U1001 2010 NISSAN VERSA Description

The Controller Area Network (CAN) is a serial communication line for real-time applications. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads the required data only.
The Diagnostic Trouble Code (DTC) sets when the Engine Control Module (ECM) is not transmitting or receiving CAN communication signals of OBD (emission-related diagnosis) for 2 seconds or more.
OBDII Code U1001 2010 Nissan Versa - Invalid or Missing Data for Primary Id - AutoCodes.com

More Information

Need more information on how to fix the U1001 2010 NISSAN VERSA code?
Get Access to Factory Service Manuals

Need more help?

Get the U1001 2010 Nissan Versa code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the U1001 2010 Nissan Versa code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧