AutoCodes
 
OBDII Code List
 
U1000 2008 NISSAN ROGUE

U1000 2008 NISSAN ROGUE - CAN Communication Line - Signal Malfunction

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

U1000 2008 NISSAN ROGUE Possible Causes

  • Controller Area Network (CAN) communication harness is open or shorted
  • Faulty Engine Control Module (ECM)
  • Poor harness ground connection.

First diagnose U1000 2008 NISSAN ROGUE code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

U1000 2008 NISSAN ROGUE Tech Notes

Usually the problem is poor harness ground connection.

There is a service bulletin for the following Nissan models with U1000 code:

Nissan Factory Service Bulletin Code U1000

The service bulletin suggests cleaning engine and body harness ground connection to repair problem.

Cost of diagnosing the U1000 2008 NISSAN ROGUE code

    Labor: 1.0

    The cost of diagnosing the U1000 2008 NISSAN ROGUE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the U1000 2008 NISSAN ROGUE code detected?

When ECM is not transmitting or receiving CAN communication signal of OBD (emission related diagnosis) for 2 seconds or more.

U1000 2008 NISSAN ROGUE Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

U1000 2008 Nissan Rogue Description

CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.

Each control unit transmits/receives data but selectively reads required data only.

OBDII Code U1000 2008 Nissan Rogue - CAN Communication Line - Signal Malfunction - AutoCodes.com

U1000 2008 NISSAN ROGUE More Information

Need more information on how to fix the U1000 2008 NISSAN ROGUE code?
Get Access to Factory Service Manuals

Need more help?

Get the U1000 2008 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area

Related Information

U1000 2008 NISSAN ROGUE Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the U1000 2008 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧