AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - U019F

U019F Code - Lost Communication With Engine Coolant Pump Control Module

- Code Popularity: 14,365 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC U019F?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Engine Coolant Pump Control Module
  • Engine Coolant Pump Control Module harness is open or shorted
  • Engine Coolant Pump Control Module circuit poor electrical connection
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC U019F?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for U019F Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the U019F code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code U019F Description

A Controller Area Network (CAN) is a vehicle bus standard designed to interconnect automotive devices without a host computer. Operating information and commands are exchanged among the devices. The devices have programmed information about what messages are needed to be exchanged on the serial data circuits. CAN bus uses two dedicated wires for communication. The wires are called CAN high and CAN low. When the CAN bus is in idle mode, both lines carry 2.5V. When data bits are being transmitted, the CAN high line goes to 3.75V, and the CAN low drops to 1.25V, thereby generating a 2.5V differential between the lines. Since communication relies on a voltage differential between the two bus lines, the CAN bus is NOT sensitive to inductive spikes, electrical fields, or other noise. The Diagnostic Trouble Code (DTC) sets when a periodic message from the Engine Coolant Pump Control Module has not been received.

OBDII Code U019F - Lost Communication With Engine Coolant Pump Control Module - AutoCodes.com
U019F Code - Lost Communication With Engine Coolant Pump Control Module

Need More Information on the Code?

Need more information on how to fix the U019F code? Get Access to Factory Service Manuals

Information for Specific Makes

  • U019F Ford Lost Communication With Engine Coolant Pump Control Module
  • U019F Lincoln Lost Communication With Engine Coolant Pump Control Module
  • U019F Mercury Lost Communication With Engine Coolant Pump Control Module

Need Help with the Code?

Get the U019F code diagnosed by a professional: Find a repair shop in your area

Code U019F comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U019F code? Have you replaced any parts?
Any information is appreciated. Thanks