AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - U0118 Ford

U0118 Ford Code - Lost Communication With Fuel Additive Control Module

- Code Popularity: 6,960 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC U0118 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Top Off Fuel Additive Tank
  • Faulty Fuel Additive Sensor
  • Faulty Fuel Additive Control Module
  • Fuel Additive Control Module harness is open or shorted
  • Fuel Additive Control Module circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC U0118 Ford?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for U0118 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the U0118 Ford code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code U0118 Ford Description

A Controller Area Network (CAN) is a vehicle bus standard designed to interconnect automotive devices without a host computer. Operating information and commands are exchanged among the devices. The devices have programmed information about what messages are needed to be exchanged on the serial data circuits. CAN bus uses two dedicated wires for communication. The wires are called CAN high and CAN low. When the CAN bus is in idle mode, both lines carry 2.5V. When data bits are being transmitted, the CAN high line goes to 3.75V, and the CAN low drops to 1.25V, thereby generating a 2.5V differential between the lines. Since communication relies on a voltage differential between the two bus lines, the CAN bus is NOT sensitive to inductive spikes, electrical fields, or other noise. The Diagnostic Trouble Code (DTC) sets when a periodic message from the Fuel Additive Control Module has not been received.

OBDII Code U0118 Ford - Lost Communication With Fuel Additive Control Module - AutoCodes.com
U0118 Ford Code - Lost Communication With Fuel Additive Control Module

Need More Information on the Code?

Need more information on how to fix the U0118 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the U0118 Ford code diagnosed by a professional: Find a repair shop in your area

Code U0118 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U0118 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks