AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - U0100 Toyota

U0100 Toyota Code - Lost Communication with Engine Control Module

- Code Popularity: 42,357 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC U0100 Toyota?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Controller Area Network (CAN) Communication System
  • Faulty Control Module
  • Control Module harness is open or shorted
  • Control Module circuit poor electrical connection
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC U0100 Toyota?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

When there are problems with the way different systems in a vehicle communicate with each other using a technology called Controller Area Network (CAN) communication, Diagnostic Trouble Codes (DTC) are displayed. These codes can be caused by issues with the main bus or branch of the communication network, or with the Electronic Control Units (ECUs) and sensors that make up the different systems. If you see code for both the CAN communication problems and internal or power source problems at the same time, you should focus on fixing the internal or power source problems first.

Search for U0100 Toyota Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the U0100 Toyota code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code U0100 Toyota Description

The Controller Area Network (CAN) is a standard bus system in vehicles that enables the connection of automotive devices without the need for a host computer. The exchange of operating information and commands among devices is facilitated by pre-programmed information about the required message exchange on the serial data circuits. Communication is carried out using two dedicated wires, known as CAN high and CAN low, with both lines carrying 2.5V when the CAN bus is in idle mode. During the transmission of data bits, the CAN high line increases to 3.75V while the CAN low drops to 1.25V, creating a 2.5V differential between the lines. Since communication relies on a voltage differential between the two bus lines, the CAN bus is NOT sensitive to inductive spikes, electrical fields, or other noise. The Diagnostic Trouble Code (DTC) sets when a message that includes the transmitter device availability has not been received.

OBDII Code U0100 Toyota - Lost Communication with Engine Control Module - AutoCodes.com
U0100 Toyota Code - Lost Communication with Engine Control Module

Need More Information on the Code?

Need more information on how to fix the U0100 Toyota code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the U0100 Toyota code diagnosed by a professional: Find a repair shop in your area

Code U0100 Toyota comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the U0100 Toyota code? Have you replaced any parts?
Any information is appreciated. Thanks