what is factory idle speed for 2013 avalanche 5.3ltr??

Question

2013 black diamond ltz avalanche 5.3 ltr 2wd factory idle speed??

Answer 1

The factory idle speed , is maintained by the ECM at Park you should be around 750 RPM, If you need to set the idle speed use this to set the idle speed.

1.Start and idle the engine for 3 minutes.
2.With a scan tool, monitor the Desired Idle Speed and the actual Engine Speed.
3.The ECM will start to learn the new idle cells and Desired Idle Speed should start to decrease.
4.Ignition OFF for 60 seconds.
5.Start and idle the engine for 3 minutes.
6.After the 3 minute run time the engine should be idling normal.

Note:
 During the drive cycle the check engine light may come on with idle speed DTCs. If idle speed codes are set, clear codes so the ECM can continue to learn.



¤ If the engine idle speed has not been learned the vehicle will need to be driven at speeds above 70 km/h (44 mph) with several decelerations and extended idles.
7.After the drive cycle, the engine should be idling normally.

¤ If the engine idle speed has not been learned, turn OFF the ignition for 60 seconds and repeat step 6.
8.Once the engine speed has returned to normal, clear DTCs and return to the diagnostic that referred you here