P0562 Chrysler - 300

Question

I have a Chrysler 300 2.7 v6 and it is over heating I hooked up the obd 2 egine light reader and code p0052 p0700 p0562 pop up what could be causing this to over heat

Answer 1

P0052 -02 sensor Bank 2 sensor 1 circuit high

P0700 Transmission fault detected, Mil ligh requested

P0562 Battery voltage low.

If the engine is over heating does the cooling fan come on? If it does and its still is overheating the waterpump is faulty, The waterpump for these engine are plastic impellel,and it is driven by the timing chain. P0562 is battery voltage low it can and will set a P0700 if there is insufficient voltage to the transmission solenoids.Transmission damage can occurs, to prevent this the TCM puts the tramsission into limp mode,Check the charging system a proper working charging system will be 2 volts above battery voltage at idle, so it would be at 14 volts. P0052 Bank 2 sensor 1 this is the upstream sensor or the engine management 02 sensor (airflow sensor) which is located where the number 2 cylinder is . being circuit high means you are disconnected or the sensor itself has shorted. Because this is a Chrysler product you cannot have new upstream 02 sensor and worn downstream 02 sensor you will code up a P0420 which is a catalytic insufficient .You cannot also have one side of the bank a new 02 sensor and the other side a worn 02 sensor this will code up a P0300 (random misfire).