0 like 0 dislike
371 views
by

Hi Reynaldo

I cleared error code, after that say about half hour car run fine and then out of blues Anti-lock and traction control light was on dash board and two minutes later SES light is on. I checked and back to code 'p0171' but shut the engine off waited for ten minutes, started the engine SES light is on but no anti-lock and traction control light is gone.

Thanks in advance

Vehicle: 1997 Buick Park Avenue Ultra 3.8 L SC

1 Answer

0 like 0 dislike
by (13.5k points)
 
Best answer
When you disconnect the MAF, the MAP takes over, If you disconnect the MAF and only P0102 is there and no P0171 then the problem is with the MAF sensor, I know you say its new, but new doesnt mean its good.MAF code P0102 is a type "A" code which means ABS and traction are disabled,

Related questions

0 like 0 dislike
1 answer 536 views
0 like 0 dislike
1 answer 391 views
0 like 0 dislike
1 answer 477 views
1 like 0 dislike
2 answers 551 views

33.7k questions

32.5k answers

1.3k comments

23.0k users

Need A Repair Shop?
Find local automotive repair shops in your area.
...