P0118 DODGE - 2001 stratus

Question

got this code replaced the engine coolant sensor still gives code, temp gauge does not move from the cold position regardless of car being warm

Answer 1

This is usually a problem with the thermostat if the gage isn't changing at all. If it is stuck open then the engine won't heat up to operating temp./

Answer 2

Description

Indicates the sensor signal is greater than the self-test maximum
the ECT sensor maximum is 4.6 volts or 50 c (58 f ) ..

Possible causes

open circuit in the harness
sensor signal short to voltage
incorrect harness connector
damaged sensor
damaged PCM

Diagnostic Aids

an ECT PID reading greater than 4.6 volts with the ignition on engine off or during any engine operating mode indicates a concern is present

Diagnostic aids

 

Using signal simulation,

disconnect sensor and

simulate 1.0V on sensor

signal circuit. Simulated

1.0V signal and scan PID

voltage value should be

similar. If voltage is similar

check sensor, if voltage is

not similar check related

circuit and PCM