AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P2769 2009 Toyota Camry

P2769 2009 Toyota Camry Code - Short in Torque Converter Clutch Solenoid Circuit

- Code Popularity: 2,523 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2769 2009 Toyota Camry?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Shift Solenoid Valve SL (V6) or DSL (4 cylinder)
  • Shift Solenoid Valve SL (V6) or DSL (4 cylinder) harness is open or shorted
  • Shift Solenoid Valve SL (V6) or DSL (4 cylinder) circuit poor electrical connection
  • Faulty Transmission Control Module (TCM)
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P2769 2009 Toyota Camry?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2769 2009 Toyota Camry Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2769 2009 Toyota Camry code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2769 2009 Toyota Camry Description

The shift solenoid valve DSL is turned "ON" and "OFF" by signals from the Engine Control Module (ECM) in order to control the hydraulic pressure operation, the lock-up relay valve, which then the controls operation of the lock-up clutch.
Torque converter lock-up is controlled by the ECM based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift range selection. The ECM determines the lock-up status of the torque converter by comparing the engine rpm (NE) to the input turbine rpm (NT). The ECM calculates the actual transmission gear by comparing input turbine rpm (NT) to counter gear rpm (NC). When conditions are appropriate, the ECM requests "lock-up" by applying control voltage to shift solenoid DSL. When the DSL is opened, solenoid DSL applies pressure to the lock-up relay valve and locks the torque converter clutch. If the ECM detects an open or short in the DSL solenoid circuit, the ECM interprets this as a fault in the DSL solenoid or circuit. The ECM will turn on the MIL and store the DTC.
OBDII Code P2769 2009 Toyota Camry - Short in Torque Converter Clutch Solenoid Circuit  - AutoCodes.com
P2769 2009 Toyota Camry Code - Short in Torque Converter Clutch Solenoid Circuit

Need More Information on the Code?

Need more information on how to fix the P2769 2009 Toyota Camry code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2769 2009 Toyota Camry code diagnosed by a professional: Find a repair shop in your area

Code P2769 2009 Toyota Camry comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2769 2009 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks