AutoCodes - Toyota - P2769 2006 TOYOTA CAMRY

P2769 2006 TOYOTA CAMRY Code - Short in Torque Converter Clutch Solenoid Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P2769 2006 TOYOTA CAMRY code possible causes

  • Faulty Shift Solenoid Valve SL (V6) or DSL (4 cylinder)
  • Shift Solenoid Valve SL (V6) or DSL (4 cylinder) harness is open or shorted
  • Shift Solenoid Valve SL (V6) or DSL (4 cylinder) circuit poor electrical connection
  • Faulty Transmission Control Module (TCM)

|How do I fix the P2769 2006 TOYOTA CAMRY code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the P2769 2006 TOYOTA CAMRY code

Labor: 1.0

The cost of diagnosing the P2769 2006 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P2769 2006 TOYOTA CAMRY code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|P2769 2006 TOYOTA CAMRY code description

The shift solenoid valve DSL is turned "ON" and "OFF" by signals from the Engine Control Module (ECM) in order to control the hydraulic pressure operation, the lock-up relay valve, which then the controls operation of the lock-up clutch.
Torque converter lock-up is controlled by the ECM based on engine rpm, engine load, engine temperature, vehicle speed, transmission temperature, and shift range selection. The ECM determines the lock-up status of the torque converter by comparing the engine rpm (NE) to the input turbine rpm (NT). The ECM calculates the actual transmission gear by comparing input turbine rpm (NT) to counter gear rpm (NC). When conditions are appropriate, the ECM requests "lock-up" by applying control voltage to shift solenoid DSL. When the DSL is opened, solenoid DSL applies pressure to the lock-up relay valve and locks the torque converter clutch. If the ECM detects an open or short in the DSL solenoid circuit, the ECM interprets this as a fault in the DSL solenoid or circuit. The ECM will turn on the MIL and store the DTC.
OBDII Code P2769 2006 Toyota Camry - Short in Torque Converter Clutch Solenoid Circuit - AutoCodes.com

|Need more information with the P2769 2006 TOYOTA CAMRY code?

Need more information on how to fix the P2769 2006 TOYOTA CAMRY code? Get Access to Factory Service Manuals

|Need help with a P2769 2006 TOYOTA CAMRY code?

Get the P2769 2006 Toyota Camry code diagnosed by a professional: Find a repair shop in your area

|P2769 2006 TOYOTA CAMRY code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2769 2006 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?