Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
There is a factory service bulletin for the following Saturn Models:
2007-2009 Saturn AURA
2007-2009 Saturn OUTLOOK
2008-2009 Saturn VUE
Saturn Factory Service Bulletin OBDII Code P2715
To diagnose the P2715 Saturn code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
The clutch pressure control solenoid 4 is part of the control solenoid valve assembly, which has no serviceable parts. The Clutch Pressure Control Solenoid 4 regulates transmission fluid pressure to the 2-6 clutch regulator valve which controls pressure to the 2-6 clutch. The Transmission Control Module (TCM) calculates the gear ratio based on the RPM signals from the Input Speed Sensor (ISS) and the Output Speed Sensor (OSS). The Transmission Control Module compares the expected transmission gear ratio to the calculated gear ratio for each commanded gear.
The Diagnostic Trouble Code (DTC) will be set when the Transmission Control Module has detected an incorrect gear ratio change when the 2-6 clutch is commanded OFF during a shift or when 2nd gear ratio is detected in 1st gear. This condition must occur 3 times.
Need more information on how to fix the P2715 Saturn code? Get Access to Factory Service Manuals
Get the P2715 Saturn code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2715 Saturn code? Have you replaced any parts?
Any information is appreciated. Thanks