AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P2619 Ford

P2619 Ford Code - Crankshaft Position Signal Output Circuit High

- Code Popularity: 1,219 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2619 Ford?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Crankshaft Position Sensor
  • Crankshaft Position Sensor harness is open or shorted
  • Crankshaft Position Sensor circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P2619 Ford?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2619 Ford Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2619 Ford code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2619 Ford Description

The Crankshaft Position Sensor is also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Engine Control Module (ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field causes the voltage from the sensor to change.

OBDII Code P2619 Ford - Crankshaft Position Signal Output Circuit High - AutoCodes.com
P2619 Ford Code - Crankshaft Position Signal Output Circuit High

Need More Information on the Code?

Need more information on how to fix the P2619 Ford code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2619 Ford code diagnosed by a professional: Find a repair shop in your area

Code P2619 Ford comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2619 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks