AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Chevrolet - P2501 Chevrolet

P2501 Chevrolet Code - High Signal Voltage On Generator Turn ON Signal Circuit

- Code Popularity: 2,205 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2501 Chevrolet?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Generator (Alternator)
  • Generator harness is open or shorted
  • Generator circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Chevrolet have Safety Recalls? → Check here

How to Fix the DTC P2501 Chevrolet?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2501 Chevrolet Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2501 Chevrolet code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2501 Chevrolet Description

The Engine Control Module (ECM) uses the generator turn ON signal circuit to control the load of the generator on the engine. A high side driver in the ECM applies a voltage to the voltage regulator. This signals the voltage regulator to turn the field circuit ON and OFF. When the ECM turns ON the high side driver, the voltage regulator turns ON the field circuit. When the ECM turns OFF the high side driver, the voltage regulator turns OFF the field circuit.
The ECM monitors the state of the generator turn ON signal circuit. The ECM should detect a low generator turn ON signal circuit voltage when the key is ON and the engine is OFF, or when the charging system malfunctions. If the ECM detects a high generator turn ON signal circuit voltage, Diagnostic Trouble Code (DTC) P2501 will set.
OBDII Code P2501 Chevrolet - High Signal Voltage On Generator Turn ON Signal Circuit - AutoCodes.com
P2501 Chevrolet Code - High Signal Voltage On Generator Turn ON Signal Circuit

Need More Information on the Code?

Need more information on how to fix the P2501 Chevrolet code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2501 Chevrolet code diagnosed by a professional: Find a repair shop in your area

Code P2501 Chevrolet comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2501 Chevrolet code? Have you replaced any parts?
Any information is appreciated. Thanks