P2422 2009 Honda Accord Code - Evaporative Emission System Vent Valve Stuck Closed
Quick Answer
The fuel tank pressure (FTP) sensor output indicates about atmospheric pressure 0 kPa (0 in.Hg, 0 mmHg) before purge starts since the evaporative emission (EVAP) canister vent shut valve is normally open (open to the atmosphere). Common causes include Faulty Evaporative Emission Vent Shut Valve, Evaporative Emission Vent Shut Valve harness is open or shorted, Evaporative Emission Vent Shut Valve circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P2422 2009 Honda Accord indicates Evaporative Emission System Vent Valve Stuck Closed.
- Common causes
- Common causes include Faulty Evaporative Emission Vent Shut Valve, Evaporative Emission Vent Shut Valve harness is open or shorted, Evaporative Emission Vent Shut Valve circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P2422 2009 Honda Accord Description
When the FTP sensor indicates vacuum after starting the engine, there is the possibility of an FTP sensor zero point shift failure or an EVAP canister vent shut valve stuck closed failure. So the Powertrain Control Module (PCM) monitors the FTP sensor output after purge starts. The PCM detects a malfunction of the EVAP canister vent shut valve if the output indicates excessive vacuum.
However, if the fuel tank internal pressure is below the specified value (excessive vacuum is detected) when starting the engine, the malfunction detection should be done as follows because it is difficult to distinguish the FTP sensor range problem (P1454) from the EVAP canister vent shut valve stuck closed (P2422).
1. If neither Temporary Diagnostic Trouble Code (DTC) (P1454 nor P2422) is stored, both DTCs are stored.
2. If both Temporary DTCs (P1454 and P2422) are stored and excessive vacuum is detected, both DTCs are stored.
3. If either Temporary DTC (P1454 or P2422) is stored and excessive vacuum is detected, the PCM stores the DTC of the Temporary DTC that was stored.
What are the Possible Causes of the DTC P2422 2009 Honda Accord?
- Faulty Evaporative Emission Vent Shut Valve
- Evaporative Emission Vent Shut Valve harness is open or shorted
- Evaporative Emission Vent Shut Valve circuit poor electrical connection
How to Fix the DTC P2422 2009 Honda Accord?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P2422 2009 Honda Accord code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P2422 2009 Honda Accord code?
Need more information on how to fix the P2422 2009 Honda Accord code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2422 2009 Honda Accord code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P2422 2009 Honda Accord Code
1. What does OBDII code P2422 in a 2009 Honda Accord mean?
- It indicates a problem with the Evaporative Emission System Vent Valve being stuck closed.
2. What are the common symptoms of a P2422 code in a 2009 Honda Accord?
- Symptoms may include the check engine light coming on, reduced fuel efficiency, and potential fuel vapor odors.
3. What are the possible causes of the Evaporative Emission System Vent Valve stuck closed in a 2009 Honda Accord?
- Common causes can be a faulty vent valve, a clogged vent filter, damaged hoses, or electrical issues.
4. How serious is the P2422 code in a 2009 Honda Accord?
- While the vehicle may still be driveable, it is important to address the issue promptly to prevent potential damage to the emission system and reduce harmful emissions.
5. Can I continue driving my 2009 Honda Accord with the P2422 code?
- It is recommended to have the issue diagnosed and repaired as soon as possible to avoid potential long-term damage and ensure the vehicle remains compliant with emissions regulations.
6. How can I diagnose the cause of a P2422 code in my 2009 Honda Accord?
- A thorough inspection of the vent valve, filter, hoses, and electrical connections is recommended, along with checking for any signs of damage or blockages.
7. How can I repair a P2422 code in my 2009 Honda Accord?
- The repair may involve replacing the vent valve, clearing any obstructions in the system, checking and replacing damaged hoses, and ensuring proper electrical connections.
8. Can I reset the check engine light after fixing a P2422 code in my 2009 Honda Accord?
- Yes, the check engine light can be reset using an OBDII scanner after the issue has been addressed and repaired.
9. How much does it typically cost to repair a P2422 code in a 2009 Honda Accord?
- The cost can vary depending on the exact cause of the issue and the labor rates in your area, but it may range from $100 to $300 for parts and labor.
10. How can I prevent the P2422 code from recurring in my 2009 Honda Accord?
- Regularly inspecting and maintaining the evaporative emission system, including checking for leaks and ensuring proper component operation, can help prevent the code from reoccurring.
Discuss the causes and fixes for P2422 2009 Honda Accord OBDII Code
Code P2422 2009 Honda Accord comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
