AutoCodes
 
OBDII Code List
 
P2402 2008 TOYOTA PRIUS

P2402 2008 TOYOTA PRIUS - EVAP System Leak Detection Pump Control Circuit High

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

Possible causes

  • Faulty Vacuum Pump Module
  • Vacuum Pump Module harness is open or shorted
  • Vacuum Pump Module circuit poor electrical connection
  • EVAP system hose (clogged, cracked or broken)
  • Faulty Engine Control Module (ECM)

Tech notes

There is a factory service bulletin for the following Toyota models:

2005–2006 Toyota Corolla
2005–2006 Toyota Matrix
Toyota Corolla, Matrix Factory Service Bulletin OBDII Code P2401

Service bulletin recommends replacing the EVAP Charcoal Canister Assembly to repair the problem.

When is the code detected?

To determine leak criterion (Reference pressure), vacuum pump creates negative pressure in canister pump module through 0.02 inch orifice and pressure is measured. If the conditions are not met, Engine Control Module (ECM) the code will be set.

Possible symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P2402 2008 Toyota Prius Description

5 hours after the ignition switch is turned OFF, the electric vacuum pump creates negative pressure (vacuum) in the EVAP (Evaporative Emission) system. The Engine Control Module (ECM) monitors for leaks and actuator malfunctions based on the EVAP pressure.
OBDII Code P2402 2008 Toyota Prius - EVAP System Leak Detection Pump Control Circuit High - AutoCodes.com

Need more help?

Get the P2402 2008 Toyota Prius code diagnosed by a professional: Find a repair shop in your area

Related Information

P2402 2008 TOYOTA PRIUS Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2402 2008 Toyota Prius code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧