AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P2402 2003 Toyota Highlander

P2402 2003 Toyota Highlander Code - EVAP System Leak Detection Pump Control Circuit High

- Code Popularity: 2,186 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2402 2003 Toyota Highlander?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Vacuum Pump Module
  • Vacuum Pump Module harness is open or shorted
  • Vacuum Pump Module circuit poor electrical connection.
  • Faulty Engine Control Module (ECM)
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P2402 2003 Toyota Highlander?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2402 2003 Toyota Highlander Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2402 2003 Toyota Highlander code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

To determine leak criterion (Reference pressure), vacuum pump creates negative pressure in canister pump module through 0.02 inch orifice and pressure is measured. If the conditions are not met, Engine Control Module (ECM) the code will be set.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2402 2003 Toyota Highlander Description

5 hours after the ignition switch is turned OFF, the electric vacuum pump creates negative pressure (vacuum) in the EVAP (Evaporative Emission) system. The Engine Control Module (ECM) monitors for leaks and actuator malfunctions based on the EVAP pressure.

OBDII Code P2402 2003 Toyota Highlander - EVAP System Leak Detection Pump Control Circuit High - AutoCodes.com
P2402 2003 Toyota Highlander Code - EVAP System Leak Detection Pump Control Circuit High

Need More Information on the Code?

Need more information on how to fix the P2402 2003 Toyota Highlander code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2402 2003 Toyota Highlander code diagnosed by a professional: Find a repair shop in your area

Code P2402 2003 Toyota Highlander comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2402 2003 Toyota Highlander code? Have you replaced any parts?
Any information is appreciated. Thanks