P2240 2006 Toyota Camry Code - Oxygen A/F Sensor Pumping Current Circuit Open Bank 2 Sensor 1
Quick Answer
The Air-Fuel ratio (A/F) sensor provides output voltage approximately equal to the existing air-fuel ratio. Common causes include Faulty Air/Fuel Sensor Bank 2, Air/Fuel Sensor Bank 2 harness is open or shorted, Air/Fuel Sensor Bank 2 circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P2240 2006 Toyota Camry indicates Oxygen A/F Sensor Pumping Current Circuit Open Bank 2 Sensor 1 .
- Common causes
- Common causes include Faulty Air/Fuel Sensor Bank 2, Air/Fuel Sensor Bank 2 harness is open or shorted, Air/Fuel Sensor Bank 2 circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P2240 2006 Toyota Camry Description
The A/F sensor output voltage is used to provide feedback for the Engine Control Module (ECM) to control the air-fuel ratio.
With the A/F sensor output, the ECM can determine deviation from the stoichiometric air-fuel ratio and control proper injection time. If the A/F sensor is malfunctioning, the ECM is unable to accurately control air-fuel ratio.
The A/F sensor is equipped with a heater which heats the zirconia element. The heater is also controlled by the ECM. When the intake air volume is low (the temperature of the exhaust gas is low), current flows to the heater which heats the sensor to facilitate detection of accurate oxygen concentration.
The A/F sensor is a planar type. Compared to a conventional type, the sensor and heater portions are narrower. Because the heat of the heater is conducted through the alumina to zirconia (of the sensor portion), sensor activation is accelerated.
The code is output when there is an open or short in the A/F sensor circuit, or if A/F sensor output drops. To detect these problems, the voltage of the A/F sensor is monitored when turning the ignition switch to the ON position, and the admittance (admittance is an electrical term that indicates the ease of flow of current) is checked while driving. If the voltage of the A/F sensor is between 0.6 V and 4.5 V, it is considered normal. If the voltage is outside of the specified range, or the admittance is less than the standard value, the ECM will determine that there is a malfunction in the A/F sensor. If the same malfunction is detected in the next driving cycle, the MIL is illuminated and a DTC is set.
What are the Possible Causes of the DTC P2240 2006 Toyota Camry?
- Faulty Air/Fuel Sensor Bank 2
- Air/Fuel Sensor Bank 2 harness is open or shorted
- Air/Fuel Sensor Bank 2 circuit poor electrical connection
- Air/Fuel Sensor Relay
- Faulty Engine Control Module (ECM)
How to Fix the DTC P2240 2006 Toyota Camry?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P2240 2006 Toyota Camry code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P2240 2006 Toyota Camry code?
Need more information on how to fix the P2240 2006 Toyota Camry code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P2240 2006 Toyota Camry code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P2240 2006 Toyota Camry Code
1. What does the OBDII code P2240 mean on a 2006 Toyota Camry?
P2240 indicates an issue with the Oxygen (A/F) Sensor Pumping Current Circuit for Bank 2 Sensor 1, specifically an open circuit.
2. What are the common symptoms of a P2240 code?
Common symptoms include poor fuel efficiency, rough idle, reduced engine performance, and an illuminated check engine light.
3. What causes the P2240 code to appear?
Potential causes include a faulty air-fuel ratio sensor, damaged wiring or connectors in the circuit, or a malfunctioning engine control module (ECM).
4. Which sensor is affected by the P2240 code?
The code affects the air-fuel ratio sensor (Bank 2 Sensor 1), which monitors the oxygen levels in the exhaust for Bank 2 cylinders.
5. How can I diagnose the P2240 code?
Diagnose the issue by inspecting the sensor wiring and connectors for damage, testing the A/F sensor for proper operation, and using a multimeter to check the circuit for continuity.
6. Can I drive my 2006 Toyota Camry with a P2240 code?
While the car may still drive, it’s not recommended as it can lead to poor fuel economy, performance issues, and potential damage to the catalytic converter.
7. How do I fix the P2240 code?
Repairs may involve replacing the air-fuel ratio sensor, repairing or replacing damaged wiring, or reprogramming/replacing the ECM if necessary.
8. How much does it cost to repair a P2240 code?
Repair costs vary but typically range from $200 to $400 for a new air-fuel ratio sensor, plus labor costs if performed at a repair shop.
9. Is the P2240 code related to the oxygen sensor?
Yes, the code is tied to the air-fuel ratio sensor, which is a more advanced type of oxygen sensor used for precise fuel mixture adjustments.
10. How do I prevent the P2240 code from recurring?
To prevent recurrence, ensure regular maintenance, avoid driving through water that could damage sensors, and inspect wiring and connectors periodically for wear.
Discuss the causes and fixes for P2240 2006 Toyota Camry OBDII Code
Code P2240 2006 Toyota Camry comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
