P2237 2006 TOYOTA CAMRY - Oxygen A/F Sensor Pumping Current Circuit Open Bank 1 Sensor 1
P2237 2006 TOYOTA CAMRY Possible Causes
- Faulty EFI Relay
- Faulty Air/Fuel Sensor Bank 1
- Air/Fuel Sensor Bank 1 harness is open or shorted
- Air/Fuel Sensor Bank 1 circuit poor electrical connection
- Faulty Engine Control Module (ECM)
How do I fix code P2237 2006 TOYOTA CAMRY?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P2237 2006 TOYOTA CAMRY code
Labor: 1.0The cost of diagnosing the P2237 2006 TOYOTA CAMRY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
P2237 2006 TOYOTA CAMRY DescriptionThe Air-Fuel ratio (A/F) sensor provides output voltage approximately equal to the existing air-fuel ratio.
The A/F sensor output voltage is used to provide feedback for the Engine Control Module (ECM) to control the air-fuel ratio.
With the A/F sensor output, the ECM can determine deviation from the stoichiometric air-fuel ratio and control proper injection time. If the A/F sensor is malfunctioning, the ECM is unable to accurately control air-fuel ratio.
The A/F sensor is equipped with a heater which heats the zirconia element. The heater is also controlled by the ECM. When the intake air volume is low (the temperature of the exhaust gas is low), current flows to the heater which heats the sensor to facilitate detection of accurate oxygen concentration.
The A/F sensor is a planar type. Compared to a conventional type, the sensor and heater portions are narrower. Because the heat of the heater is conducted through the alumina to zirconia (of the sensor portion), sensor activation is accelerated.
The code is output when there is an open or short in the A/F sensor circuit, or if A/F sensor output drops. To detect these problems, the voltage of the A/F sensor is monitored when turning the ignition switch to the ON position, and the admittance (admittance is an electrical term that indicates the ease of flow of current) is checked while driving. If the voltage of the A/F sensor is between 0.6 V and 4.5 V, it is considered normal. If the voltage is outside of the specified range, or the admittance is less than the standard value, the ECM will determine that there is a malfunction in the A/F sensor. If the same malfunction is detected in the next driving cycle, the MIL is illuminated and a DTC is set.
More InformationNeed more information on how to fix the P2237 2006 TOYOTA CAMRY code?
Get Access to Factory Service Manuals
Need more help?Get the P2237 2006 Toyota Camry code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2237 2006 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks