AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P2197 2011 Toyota Camry

P2197 2011 Toyota Camry Code - Oxygen Sensor Signal Stuck Lean Bank 2 Sensor 1

- Code Popularity: 2,631 Views
- Repair Importance Level: 2/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2197 2011 Toyota Camry?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Oxygen Sensor Bank 2 Sensor 1
  • Oxygen Sensor Bank 2 Sensor 1 harness is open or shorted
  • Oxygen Sensor Bank 2 Sensor 1 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P2197 2011 Toyota Camry?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2197 2011 Toyota Camry Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2197 2011 Toyota Camry code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P2197 2011 Toyota Camry Description

The Engine Control Module (ECM) uses the heated oxygen sensor information to regulate the air-fuel ratio close to a stoichiometric ratio. This maximizes the catalytic converter’s ability to purify the exhaust gas. The sensor detects oxygen levels in the exhaust gas and sends this signal to the ECM. The inner surface of the sensor element is exposed to outside air. The outer surface of the sensor element is exposed to exhaust gas. The sensor element is made of platinum coated zirconia and includes an inte- grated heating element. The heated oxygen sensor has the characteristic whereby its output voltage changes suddenly in the vicinity of the stoichiometric air-fuel ratio. The heated oxygen sensor generates output voltage between 0 V and 1.0 V in response to the oxygen concentration in exhaust gas. When the output voltage of the heated oxygen sensor is 0.55 V or more, the ECM judges that the air-fuel ratio is RICH. When it is 0.4 V or less, the ECM judges that the air-fuel ratio is LEAN. Under normal condition, the output voltage from the heated oxygen sensor alternates RICH and LEAN sides periodically. If the heated oxygen sensor outputs RICH signal (or LEAN signal) constantly, or if the heated oxygen sensor cannot output enough voltage to reach the minimum specification, the ECM interprets this as a malfunction in the heated oxygen sensor and sets a DTC.

OBDII Code P2197 2011 Toyota Camry - Oxygen Sensor Signal Stuck Lean Bank 2 Sensor 1 - AutoCodes.com
P2197 2011 Toyota Camry Code - Oxygen Sensor Signal Stuck Lean Bank 2 Sensor 1

Need More Information on the Code?

Need more information on how to fix the P2197 2011 Toyota Camry code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2197 2011 Toyota Camry code diagnosed by a professional: Find a repair shop in your area

Code P2197 2011 Toyota Camry comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2197 2011 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks