AutoCodes
 
OBDII Code List
 
P2138 2012 FORD FUSION

P2138 2012 FORD FUSION - Throttle/Pedal Position Sensor/Switch 'D'/'E' Voltage Correlation

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P2138 2012 FORD FUSION Possible Causes

  • Faulty Accelerator Pedal Position (APP) Sensor
  • Accelerator Pedal Position (APP) Sensor harness is open or shorted
  • Accelerator Pedal Position (APP) Sensor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

First diagnose P2138 2012 FORD FUSION code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the P2138 2012 FORD FUSION code

    Labor: 1.0

    The cost of diagnosing the P2138 2012 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

P2138 2012 FORD FUSION Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No throttle pedal response

P2138 2012 Ford Fusion Description

The Accelerator Pedal Position (APP) sensor is an input to the Powertrain Control Module (PCM) and used to determine the amount of torque requested by the operator. There are 2 pedal position signals in the sensor. Both signals, APP and APP2, have a positive slope (increasing angle, increasing voltage), but are offset and increase at different rates. The 2 pedal position signals make sure the PCM receives a correct input even if 1 signal has a concern. The PCM determines if a signal is incorrect by calculating where it should be, inferred from the other signals. If a concern is present with one of the circuits the other input is used. There are 2 reference voltage circuits, 2 signal return circuits, and 2 signal circuits (a total of 6 circuits and pins) between the PCM and the APP sensor assembly. The pedal position signal is converted to pedal travel degrees (rotary angle) by the PCM. The software converts these degrees to counts, which is the input to the torque based strategy. If the APP sensor inputs APP1 and APP2 disagree on the position of the accelerator pedal by more than an expected value, the P2138 is set.
OBDII Code P2138 2012 Ford Fusion - Throttle/Pedal Position Sensor/Switch 'D'/'E' Voltage Correlation - AutoCodes.com

P2138 2012 FORD FUSION More Information

Need more information on how to fix the P2138 2012 FORD FUSION code?
Get Access to Factory Service Manuals

Need more help?

Get the P2138 2012 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Related Information

P2138 2012 FORD FUSION Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2138 2012 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧