P2135 2011 TOYOTA CAMRY - Throttle/Pedal Position Sensor/Switch 'A'/'B' Voltage Correlation
- Faulty electric throttle control actuator (TP sensor 1 and 2)
- Throttle Position Sensor harness is open or shorted
- Throttle Position Sensor circuit poor connection
- Faulty accelerator pedal position sensor
- Engine Light ON (or Service Engine Soon Warning Light)
P2135 2011 Toyota Camry DescriptionThe TP sensor is mounted on the throttle body, and detects the opening angle of the throttle valve. This sensor is a non-contact type. It uses Hall-effect elements in order to yield accurate signals even in extreme driving conditions, such as at high speeds as well as very low speeds. The TP sensor has two sensor circuits which each transmits a signal, VTA1 and VTA2. VTA1 is used to detect the throttle valve angle and VTA2 is used to detect malfunctions in VTA1. The sensor signal voltages vary between 0 V and 5 V in proportion to the throttle valve opening angle, and are transmitted to the VTA terminals of the ECM.
As the valve closes, the sensor output voltage decreases and as the valve opens, the sensor output voltage increases. The ECM calculates the throttle valve opening angle according to these signals and controls the throttle actuator in response to driver inputs. These signals are also used in calculations such as air-fuel ratio correction, power increase correction and fuel-cut control.
Need more help?Get the P2135 2011 Toyota Camry code diagnosed by a professional: Find a repair shop in your area
P2135 2011 TOYOTA CAMRY CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2135 2011 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks