P2135 2010 NISSAN ROGUE - Throttle Position Sensor Circuit Range/Performance
- Faulty Electric Throttle Control Actuator (TP sensor 1 and 2)
- Electric Throttle Control Actuator harness is open or shorted
- Electric Throttle Control Actuator circuit poor connection
- Faulty Accelerator Pedal Position Sensor
Tech notesTry to clean the throttle body, adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.
Nissan Rogue Idle Air Volume Relearn
When is the code detected?The code P2135 is set when the and incorrect voltage is sent to the Engine Control Module (ECM) compared with the signals from Throttle Position (TP) sensor 1 and Throttle Position (TP) sensor 2
- Engine Light ON (or Service Engine Soon Warning Light)
P2135 2010 Nissan Rogue DescriptionElectric Throttle Control Actuator consists of throttle control motor, throttle position sensor, etc. The throttle position sensor responds to the throttle valve movement.
The throttle position sensor has the two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the Engine Control Module (ECM). In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.
Need more help?Get the P2135 2010 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
P2135 2010 NISSAN ROGUE CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2135 2010 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks