AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P2123 2008 Nissan Maxima

P2123 2008 Nissan Maxima Code - Accelerator Pedal Position Sensor Circuit Range/Performance

- Code Popularity: 2,182 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P2123 2008 Nissan Maxima?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Accelerator Pedal Position Sensor
  • Accelerator Pedal Position Sensor harness is open or shorted
  • Accelerator Pedal Position Sensor circuit poor electrical connection
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P2123 2008 Nissan Maxima?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P2123 2008 Nissan Maxima Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P2123 2008 Nissan Maxima code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • No Accelerator Pedal respsonse

Code P2123 2008 Nissan Maxima Description

The Accelerator Pedal Position (APP) sensor is installed on the upper end of the accelerator pedal assembly. The sensor detects the accelerator position and sends a signal to the Engine Control Module (ECM). Accelerator pedal position sensor has two sensors. These sensors are a kind of potentiometers which transform the accelerator pedal position into output voltage, and emit the voltage signal to the ECM. In addition, these sensors detect the opening and closing speed of the accelerator pedal and feed the voltage signals to the ECM. The ECM judges the current opening angle of the accelerator pedal from these signals and controls the throttle control motor based on these signals. Idle position of the accelerator pedal is determined by the ECM receiving the signal from the accelerator pedal position sensor. The ECM uses this signal for the engine operation such as fuel cut.
OBDII Code P2123 2008 Nissan Maxima - Accelerator Pedal Position Sensor Circuit Range/Performance - AutoCodes.com
P2123 2008 Nissan Maxima Code - Accelerator Pedal Position Sensor Circuit Range/Performance

Need More Information on the Code?

Need more information on how to fix the P2123 2008 Nissan Maxima code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P2123 2008 Nissan Maxima code diagnosed by a professional: Find a repair shop in your area

Code P2123 2008 Nissan Maxima comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P2123 2008 Nissan Maxima code? Have you replaced any parts?
Any information is appreciated. Thanks