AutoCodes
 
OBDII Code List
 
P2110 2009 FORD FUSION

P2110 2009 FORD FUSION - Throttle Actuator Control System - Forced Limited RPM

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P2110 2009 FORD FUSION Possible Causes

  • Faulty Throttle Actuator Control (TAC) Motor
  • Throttle Actuator Control (TAC) Motor harness is open or shorted
  • Throttle Actuator Control (TAC) Motor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

First diagnose P2110 2009 FORD FUSION code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the P2110 2009 FORD FUSION code

    Labor: 1.0

    The cost of diagnosing the P2110 2009 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

P2110 2009 FORD FUSION Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light

P2110 2009 Ford Fusion Description

The electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2110 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced limited RPM.

OBDII Code P2110 2009 Ford Fusion - Throttle Actuator Control System - Forced Limited RPM - AutoCodes.com

P2110 2009 FORD FUSION More Information

Need more information on how to fix the P2110 2009 FORD FUSION code?
Get Access to Factory Service Manuals

Need more help?

Get the P2110 2009 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Related Information

P2110 2009 FORD FUSION Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2110 2009 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧