P2107 2008 FORD FUSION - Throttle Actuator Control Module Processor
P2107 2008 Ford Fusion DescriptionThe electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2107 code is set when the Electronic Throttle Control (ETC) control area of the Powertrain Control Module (PCM) failed test. Fault code could the result of incorrect Throttle Position (TP) command of the Throttle Actuator Control Module (TACM).
Need more help?Get the P2107 2008 Ford Fusion code diagnosed by a professional: Find a repair shop in you area
P2107 2008 FORD FUSION CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2107 2008 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks