OBDII Code List
P2106 1998 FORD F150

P2106 1998 FORD F150 - Throttle Actuator Control System - Forced Limited Power

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P2106 1998 FORD F150 Possible Causes

  • Throttle Actuator Control Motor is stuck open or closed
  • Faulty Throttle Actuator Control Motor
  • Throttle Actuator Control Motor harness is open or shorted
  • Throttle Actuator Control Motor circuit poor electrical connection
  • Faulty Powertrain Control Module (PCM)

First diagnose P2106 1998 FORD F150 code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P2106 1998 FORD F150 Tech Notes

The P2106 code is an informational code and may be set in combination with a number of other codes which are causing the FMEM. Diagnose other codes first. Do not install a new Electronic Throttle Body (ETB) for this code.

Cost of diagnosing the P2106 1998 FORD F150 code

    Labor: 1.0

    The cost of diagnosing the P2106 1998 FORD F150 code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

P2106 1998 FORD F150 Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P2106 1998 Ford F150 Description

The electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2106 code is set when the TAC system is in the Failure Mode Effects Management (FMEM) mode of forced limited power. The P2106 indicates the FMEM action is in effect due to a concern in an Electronic Throttle Control (ETC) related component or module
OBDII Code P2106 1998 Ford F150 - Throttle Actuator Control System - Forced Limited Power -

P2106 1998 FORD F150 More Information

Need more information on how to fix the P2106 1998 FORD F150 code?
Get Access to Factory Service Manuals

Need more help?

Get the P2106 1998 Ford F150 code diagnosed by a professional: Find a repair shop in your area

Related Information

P2106 1998 FORD F150 Comments

Help us improve Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2106 1998 Ford F150 code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧