P2105 2009 FORD FUSION - Throttle Actuator Control System - Forced Engine Shutdown
- Faulty Throttle Actuator Control (TAC)
- Throttle Actuator Control (TAC) harness is open or shorted
- Throttle Actuator Control (TAC) circuit poor electrical connection
Tech notesThe P2105 code is an informational code and may be set in combination with a number of other codes which are causing the FMEM. Diagnose other codes first.
- Engine Light ON (or Service Engine Soon Warning Light)
P2105 2009 Ford Fusion DescriptionThe electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2105 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced engine shutdown.
Need more help?Get the P2105 2009 Ford Fusion code diagnosed by a professional: Find a repair shop in your area
P2105 2009 FORD FUSION CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2105 2009 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks