P2104 2012 FORD MUSTANG - Throttle Actuator Control System Forced Idle
Tech notesThe P2104 code is an informational code only and may set in combination with a number of other codes which are causing the Failure Mode Effects Management (FMEM). If other codes are present, diagnose other codes first.
When is the code detected?The P2104 code is an informational code only and may set in combination with a number of other codes which are causing the Failure Mode Effects Management (FMEM).
P2104 2012 Ford Mustang DescriptionThe electronic Throttle Actuator Control (TAC) is a DC motor controlled by the Powertrain Control Module (PCM). There are 2 designs for the TAC, parallel and inline. The parallel design has the motor under the bore parallel to the plate shaft. The motor housing is integrated into the main housing. The inline design has a separate motor housing. An internal spring is used in both designs to return the throttle plate to a default position. The default position is typically a throttle angle of 7 to 8 degrees from the hard stop angle. The closed throttle plate hard stop prevents the throttle from binding in the bore. This hard stop setting is not adjustable and is set to result in less airflow than the minimum engine airflow required at idle. The P2104 code is set when the Throttle Actuator Control (TAC) system is in the Failure Mode Effects Management (FMEM) mode of forced idle.
Need more help?Get the P2104 2012 Ford Mustang code diagnosed by a professional: Find a repair shop in you area
P2104 2012 FORD MUSTANG CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2104 2012 Ford Mustang code? Have you replaced any parts?
Any information is appreciated. Thanks