P207F GMC - Reductant Quality Performance

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

P207F GMC Possible Causes

  • Degraded, Diluted or Incorrect Diesel Exhaust Fluid
  • Exhaust System leak
  • Diesel Exhaust Fluid Deposit in Def Injector Decomp Tube
  • Defective SCR Catalyst

First diagnose P207F GMC code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P207F GMC Tech Notes

There is a factory service bulletin for the following GMC models:
2010 GMC Savana
2011 GMC Savana
2011 GMC Sierra
GMC Factory Service Bulletin OBDII Code P207F

Cost of diagnosing the P207F GMC code

    Labor: 1.0

    The cost of diagnosing the P207F GMC code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

P207F GMC Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P207f Gmc Description

The aftertreatment system is equipped with two Nox Sensors and modules. The upstream NOx Sensor 1/1 is located on the Turbocharger elbow downpipe and is permanently connected to a corresponding Nox Sensor Module mounted to the hot side of the engine block. The downstream NOx Sensor 1/2 is located at the outlet of the SCR Catalyst and is permanently connected to a corresponding Nox Sensor Module which is mounted on the right frame rail. The NOx Sensors and NOx Sensor Modules are calibrated to each other and must be replaced as an assembly. The two NOx Sensor and Module assemblies are not interchangeable. The NOx Sensor Modules are smart devices and communicate with the Powertrain Control Module (PCM) over the J1939 Data Link. The NOx Sensor Modules perform their own internal diagnostics and report malfunctions back to the PCM. The NOx Sensors are used to monitor the efficiency of the SCR Catalyst and dosing system. The PCM will illuminate the Malfunction Indicator Lamp (MIL) after the diagnostic runs and fails in two consecutive drive cycles. The PCM will turn off the MIL immediately after the monitor runs and passes.

OBDII Code P207f Gmc - Reductant Quality Performance - AutoCodes.com

P207F GMC More Information

Need more information on how to fix the P207F GMC code?
Get Access to Factory Service Manuals

Need more help?

Get the P207f Gmc code diagnosed by a professional: Find a repair shop in your area

Related Information

P207F GMC Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P207f Gmc code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧