P207C MERCURY - Intake Manifold Tuning Valve Position Sensor/Switch Circuit Low Bank 2
P207C MERCURY Possible Causes
- Faulty Intake Manifold Tuning Valve Position Sensor/Switch
- Intake Manifold Tuning Valve Position Sensor/Switch harness is open or shorted
- Intake Manifold Tuning Valve Position Sensor/Switch circuit poor electrical connection
- Faulty Intake Manifold Tuning Valve (IMTV)
- Faulty Intake Manifold Runner Control (IMRC)
- Faulty Powertrain Control Module (PCM)
First diagnose P207C MERCURY code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.
Cost of diagnosing the P207C MERCURY code
Labor: 1.0The cost of diagnosing the P207C MERCURY code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
P207C MERCURY Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
P207c Mercury DescriptionThe Intake Manifold Tuning Valve (IMTV) is a motorized actuated unit mounted directly to the intake manifold. The IMTV actuator controls a shutter device attached to the actuator shaft. There is no monitor input to the Powertrain Control Module (PCM) with this system to indicate shutter position.
The motorized IMTV unit will not be energized below approximately 2600 rpm or higher on some vehicles. The shutter will be in the closed position not allowing airflow blend to occur in the intake manifold. Above approximately 2600 rpm or higher, the motorized unit will be energized. The motorized unit will be commanded on by the PCM initially at a 100 percent duty cycle to move the shutter to the open position and then falling to approximately 50 percent to continue to hold the shutter open.
The Intake Manifold Tuning Valve (IMTV) system is monitored for failure during continuous, Key ON Engine OFF (KOEO), or Key ON Engine Running (KOER) self-tests. The test fails when the signal is more or less than an expected calibrated range.
P207C MERCURY More InformationNeed more information on how to fix the P207C MERCURY code?
Get Access to Factory Service Manuals
Need more help?Get the P207c Mercury code diagnosed by a professional: Find a repair shop in your area
P207C MERCURY CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P207c Mercury code? Have you replaced any parts?
Any information is appreciated. Thanks