P2014 2009 FORD FUSION - Intake Manifold Runner Position Sensor/Switch Circuit Bank 1
P2014 2009 FORD FUSION Possible Causes
- Intake manifold runner control monitor circuit open
- Mechanical concern
- bind, seize, damage or obstruction of IMRC hardware
How do I fix code P2014 2009 FORD FUSION?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the P2014 2009 FORD FUSION code
Labor: 1.0The cost of diagnosing the P2014 2009 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
P2014 2009 FORD FUSION DescriptionThe Intake Manifold Runner Control (IMRC) system is monitored for failure during continuous or Key On Engine Off (KOEO) self-test. Each code distinguishes the corresponding bank for IMRC actuator assemblies with dual monitor switches. The test fails when the signal on the monitor pin is outside an expected calibrated range.
More InformationNeed more information on how to fix the P2014 2009 FORD FUSION code?
Get Access to Factory Service Manuals
Need more help?Get the P2014 2009 Ford Fusion code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2014 2009 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks