AutoCodes
 
OBDII Code List
 
P2008 2011 FORD FUSION

P2008 2011 FORD FUSION - Intake Manifold Runner Control Circuit/Open Bank 1

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3   
Comments  |  Add Comment

P2008 2011 FORD FUSION Possible Causes

  • Intake Manifold Runner Binding Or Sticking
  • Vacuum Line Cracked or Broken (Vacuum Leak)
  • Intake Manifold Runner Position Sensor 1 or Wiring

First diagnose P2008 2011 FORD FUSION code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

Cost of diagnosing the P2008 2011 FORD FUSION code

    Labor: 1.0

    The cost of diagnosing the P2008 2011 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the P2008 2011 FORD FUSION code detected?

P2008 indicates a failure in the IMRC primary control circuit.

P2008 2011 FORD FUSION Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P2008 2011 Ford Fusion Description

The Intake Manifold Runner Control (IMRC) is an electrically actuated system consisting of a motorized actuator with an attaching linkage for each housing on each bank. The linkage attaches to the housing butterfly plate levers. Each IMRC housing is an aluminum casting with two intake air passages for each cylinder. One passage is always open and the other is opened and closed with a butterfly valve plate. The housing uses a return spring to hold the plates closed. The motorized actuator houses internal switches to provide feedback to the Powertrain Control Module (PCM), indicating linkage and plate position. Under about 3000 rpm the vacuum solenoid will be energized. This will allow manifold vacuum to be applied and the butterfly valve plates to stay closed. Above approximately 3000 rpm , the vacuum solenoid will be de-energized. This will allow vacuum to vent from the actuator and the butterfly valve plates to open.
OBDII Code P2008 2011 Ford Fusion - Intake Manifold Runner Control Circuit/Open Bank 1 - AutoCodes.com

P2008 2011 FORD FUSION More Information

Need more information on how to fix the P2008 2011 FORD FUSION code?
Get Access to Factory Service Manuals

Need more help?

Get the P2008 2011 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Related Information

P2008 2011 FORD FUSION Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P2008 2011 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧