P1B0B Buick Code - Drive Motor 1 Control Module Hybrid/EV Battery Voltage Isolation Sensing Circuit 2 Low Voltage

The power inverter module, often referred to as the drive motor generator power inverter module, contains two motor control modules. Each motor control module measures hybrid battery high voltage with several internal sensors. The motor control modules test for loss of isolation between either the high-voltage positive circuit or high-voltage negative circuit and vehicle chassis. The motor control modules test for isolation when the high-voltage contactor relays are closed. The hybrid powertrain control module 2 only tests the hybrid battery assembly for high-voltage loss of isolation when the high-voltage contactor relays are open.
Motor control module loss of isolation is detected through the use of two high-impedance resistors and voltage measuring circuitry. The two resistors are connected in series between the high- voltage positive and high-voltage negative circuits. The centre connection of the two resistors is also connected to vehicle chassis. The motor control module then measures the voltage drop across one of the resistors. Without a loss of isolation, the motor control module should measure about half of the high voltage potential. This is referred to as mid-pack voltage. The Mid-pack voltage value is then doubled by the software and displayed on a scan tool as Motor 1 Isolation Voltage or Motor 2 Isolation Voltage. When a loss of isolation is present, the motor isolation voltage display will indicate voltage that is more or less than actual hybrid battery high voltage. The motor control module monitors the loss of isolation voltage measuring circuitry for correct operation.

• Faulty Drive Motor 1 Control Module Hybrid/EV Battery
• Drive Motor 1 Control Module Hybrid/EV Battery harness is open or shorted
• Drive Motor 1 Control Module Hybrid/EV Battery circuit poor electrical connection