P1810 CADILLAC - Transmission Fluid Pressure Valve Position Switch Circuit
When is the code detected?When the Powertrain Control Module (PCM) detects an invalid state of the Transmission Fluid Pressure (TFP) manual valve position switch circuit by deciphering the TFP manual valve position switch inputs, then the P1810 code sets.
P1810 Cadillac DescriptionThe automatic Transmission Fluid Pressure (TFP) manual valve position switch consists of five pressure switches (two normally-closed and three normally-open) and a Transmission Fluid Temperature (TFT) sensor combined into one unit. The combined unit mounts on the valve body.
The Powertrain Control Module (PCM) supplies ignition voltage for each range signal. By grounding one or more of the circuits through various combinations of the pressure switches, the PCM detects which manual valve position you select. The PCM compares the actual voltage combination of the switches to a TFP manual valve position switch combination table stored in memory.
The TFP manual valve position switch cannot distinguish between PARK and NEUTRAL because the monitored valve body pressures are identical. With the engine OFF and the ignition switch in the RUN position, the TFP manual valve position switch indicates PARK or NEUTRAL. Disconnecting the AT inline 20-way connector removes the ground potential for the three range signals to the PCM. In this case, with the engine OFF, and the ignition switch in the RUN position, D2 will be indicated.
Need more help?Get the P1810 Cadillac code diagnosed by a professional: Find a repair shop in you area
P1810 CADILLAC CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1810 Cadillac code? Have you replaced any parts?
Any information is appreciated. Thanks