AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P1490 2003 Nissan Altima Sedan

P1490 2003 Nissan Altima Sedan Code - Vacuum Cut Valve Bypass Valve

- Code Popularity: 6,461 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1490 2003 Nissan Altima Sedan?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Vacuum Cut Valve Bypass Valve
  • Clogged vacuum hoses to the Vacuum Cut Valve Bypass Valve
  • Vacuum cut valve bypass valve harness is open or shorted
  • Vacuum cut valve bypass valve electrical circuit poor connection
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P1490 2003 Nissan Altima Sedan?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

There is a factory service bulletin for the 2003 Nissan Altima:
2003 Nissan Altima Factory Service Bulletin OBDII Code P1490

Search for P1490 2003 Nissan Altima Sedan Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1490 2003 Nissan Altima Sedan code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

An improper voltage signal is sent to ECM through vacuum cut valve bypass valve.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1490 2003 Nissan Altima Sedan Description

The vacuum cut valve and vacuum cut valve bypass valve are installed in parallel on the EVAP purge line between the fuel tank and the EVAP canister.
The vacuum cut valve prevents the intake manifold vacuum from being applied to the fuel tank. The vacuum cut valve bypass valve is a solenoid type valve and generally remains closed. It opens only for on board diagnosis.
The vacuum cut valve bypass valve responds to signals from the Engine Control Module (ECM). When the ECM sends an ON (ground) signal, the valve is opened. The vacuum cut valve is then bypassed to apply intake manifold vacuum to the fuel tank.

OBDII Code P1490 2003 Nissan Altima Sedan - Vacuum Cut Valve Bypass Valve - AutoCodes.com
P1490 2003 Nissan Altima Sedan Code - Vacuum Cut Valve Bypass Valve

Need More Information on the Code?

Need more information on how to fix the P1490 2003 Nissan Altima Sedan code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1490 2003 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area

Code P1490 2003 Nissan Altima Sedan comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1490 2003 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks