P1446 2003 Nissan Sentra Code - EVAP Canister Vent Control Valve Close
Quick Answer
The EVAP canister vent control valve is located on the EVAP canister and is used to seal the canister vent. Common causes include Faulty EVAP Pressure Sensor, EVAP Pressure Sensor harness is open or shorted, EVAP Pressure Sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P1446 2003 Nissan Sentra indicates EVAP Canister Vent Control Valve Close.
- Common causes
- Common causes include Faulty EVAP Pressure Sensor, EVAP Pressure Sensor harness is open or shorted, EVAP Pressure Sensor circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P1446 2003 Nissan Sentra Description
This solenoid valve responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.
This solenoid valve is used only for diagnosis, and usually, remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP Control System (Small Leak) diagnosis.
What are the Possible Causes of the DTC P1446 2003 Nissan Sentra?
- Faulty EVAP Pressure Sensor
- EVAP Pressure Sensor harness is open or shorted
- EVAP Pressure Sensor circuit poor electrical connection
- Blocked rubber tube to EVAP canister vent control valve
- EVAP Water separator
- EVAP canister is saturated with water
- Faulty EVAP canister vent control valve
How to Fix the DTC P1446 2003 Nissan Sentra?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P1446 2003 Nissan Sentra code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P1446 2003 Nissan Sentra code?
Need more information on how to fix the P1446 2003 Nissan Sentra code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P1446 2003 Nissan Sentra code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P1446 2003 Nissan Sentra Code
1. What does OBDII code P1446 on a 2003 Nissan Sentra mean?
The code P1446 on a 2003 Nissan Sentra indicates a problem with the EVAP Canister Vent Control Valve Close function.
2. What are the common symptoms of a P1446 code on a 2003 Nissan Sentra?
Common symptoms of a P1446 code may include a check engine light, rough idling, decreased fuel efficiency, and a gasoline odor near the vehicle.
3. What causes the P1446 code to trigger on a 2003 Nissan Sentra?
The P1446 code on a 2003 Nissan Sentra is often triggered by a faulty EVAP Canister Vent Control Valve, a leak in the EVAP system, or a clogged vent valve.
4. How can I diagnose a P1446 code on my 2003 Nissan Sentra?
To diagnose a P1446 code, you can perform a visual inspection of the EVAP system components, check for leaks, test the vent control valve, and use an OBDII scanner to read the code.
5. Can I continue driving my 2003 Nissan Sentra with a P1446 code?
While it may be possible to drive the vehicle with a P1446 code, it is recommended to address the issue promptly to prevent further damage to the EVAP system and ensure optimal vehicle performance.
6. How can I repair a P1446 code on my 2003 Nissan Sentra?
Repairing a P1446 code may involve replacing the EVAP Canister Vent Control Valve, repairing any leaks in the system, clearing the code with an OBDII scanner, and conducting a drive cycle to ensure the code does not return.
7. Are there any DIY tips for fixing a P1446 code on a 2003 Nissan Sentra?
While some basic troubleshooting steps can be performed by DIY enthusiasts, it is recommended to consult a professional mechanic for accurate diagnosis and repair of a P1446 code to ensure proper functioning of the EVAP system.
8. How much does it cost to repair a P1446 code on a 2003 Nissan Sentra?
The cost of repairing a P1446 code on a 2003 Nissan Sentra can vary depending on the root cause of the issue, the cost of parts, and labor charges. It is advisable to obtain quotes from different auto repair shops for an accurate estimate.
9. Can a P1446 code on a 2003 Nissan Sentra cause emissions testing failure?
Yes, a P1446 code can cause a vehicle to fail emissions testing as it indicates a problem with the EVAP system, which is crucial for controlling harmful emissions from the vehicle.
10. How often does the EVAP Canister Vent Control Valve Close need to be replaced in a 2003 Nissan Sentra?
The EVAP Canister Vent Control Valve Close may need to be replaced as part of regular maintenance or when it fails due to wear and tear, typically every 50,000 to 70,000 miles depending on driving conditions.
Discuss the causes and fixes for P1446 2003 Nissan Sentra OBDII Code
Code P1446 2003 Nissan Sentra comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
