What are the Possible Causes of the DTC P1442 Lincoln?
NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
Open or faulty gas cap
Small leak in EVAP system-Check vent solenoid
Faulty hose connection or leak in line
⚠ Does your Lincoln have Safety Recalls? → Check here
How to Fix the DTC P1442 Lincoln?
Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
There is a factory service bulletin for the following Lincoln vehicles:
1997-1998 Lincoln Mark VIII
1997-2002 Lincoln Continental
1997-2003 Lincoln Town Car
2000-2003 Lincoln LS
1998-2003 Lincoln Navigator
2002-2003 Lincoln Blackwood Lincoln Factory Service Bulletin OBDII Code P1442
Search for P1442 Lincoln Questions and Answers: Search here →
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P1442 Lincoln code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
What are Code Possible Symptoms?
Engine Light ON (or Service Engine Soon Warning Light)
Code P1442 Lincoln Description
This diagnosis detects leaks in the Evaporative Emission System (EVAP) purge line using an engine intake manifold vacuum. If pressure does not increase, the Engine Control Module (ECM) will check for leaks in the line between the fuel tank and EVAP canister purge volume control solenoid valve under the following vacuum test condition.
The vacuum cut valve bypass valve is opened to clear the line between the fuel tank and the EVAP canister purge volume control solenoid valve. The EVAP canister vent control valve will then be closed to shut the EVAP purge line off. The EVAP canister purge volume control solenoid valve is opened to depressurize the EVAP purge line using intake manifold vacuum. After this depressurization is implemented, the EVAP canister purge volume control solenoid valve will be closed.
The Diagnostic Trouble Code (DTC) will set when the EVAP control system has a small leak such as the loose fuel filler cap, the EVAP control system does not operate properly.
P1442 Lincoln Code - EVAP System Small Leak Detected
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1442 Lincoln code? Have you replaced any parts? Any information is appreciated. Thanks