AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Honda - P1382 1999 Honda Civic

P1382 1999 Honda Civic Code - Cylinder Position Sensor 1 No Signal

- Code Popularity: 7,154 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1382 1999 Honda Civic?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Cylinder Position Sensor (Inside Distributor)
  • Cylinder Position Sensor harness is open or shorted
  • Cylinder Position Sensor circuit poor electrical connection
⚠ Does your Honda have Safety Recalls? → Check here

How to Fix the DTC P1382 1999 Honda Civic?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

The Cylinder Position (CYP) Sensor, Crankshaft Position Sensor (CKP) and Top Dead Center (TDC) Sensor are all built into the distributor.

Search for P1382 1999 Honda Civic Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1382 1999 Honda Civic code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1382 1999 Honda Civic Description

The Crankshaft Position (CKP) Sensor determines the timing for fuel injection and ignition of each cylinder and also detects engine speed. The Top Dead Center (TDC) Sensor determines ignition timing at start-up (cranking) and when the crank angle is abnormal. The Cylinder Position (CYP) Sensor detects the position of the No. 1 cylinder for the sequential fuel injection to each cylinder. The CKP/TDC/CYP sensors are built into the distributor. If no cylinder position (CYP) sensor pulsing signals are detected, a malfunction is detected, and the P1382 Diagnostic Trouble Code (DTC) is stored.

OBDII Code P1382 1999 Honda Civic - Cylinder Position Sensor 1 No Signal - AutoCodes.com
P1382 1999 Honda Civic Code - Cylinder Position Sensor 1 No Signal

Need More Information on the Code?

Need more information on how to fix the P1382 1999 Honda Civic code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1382 1999 Honda Civic code diagnosed by a professional: Find a repair shop in your area

Code P1382 1999 Honda Civic comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1382 1999 Honda Civic code? Have you replaced any parts?
Any information is appreciated. Thanks