AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Volkswagen - P1360 Volkswagen

P1360 Volkswagen Code - Ignition Circuit Cylinder 2 Short to Ground

- Code Popularity: 6,488 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1360 Volkswagen?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Ignition Coil Cylinder 2
  • Ignition Coil Cylinder 2 harness is open or shorted
  • Ignition Coil Cylinder 2 circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Volkswagen have Safety Recalls? → Check here

How to Fix the DTC P1360 Volkswagen?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1360 Volkswagen Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1360 Volkswagen code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1360 Volkswagen Description

The Engine Control Module (ECM) must determine if a misfire is occurring and identify the specific cylinder(s) and the severity of the misfire event and whether it is emissions relevant or catalyst damaging. In order to accomplish these tasks, the control module monitors the crankshaft for acceleration losses during firing segments of each cylinder based on the firing order.
The misfire/engine roughness calculation is derived from the differences in the period duration (T) of individual increment gear segments. Each segment period consists of an angular range of 120° crank angle that starts 78° before the Top Dead Center (TDC).
If the expected period duration is greater than the permissible value a misfire fault for the particular cylinder is stored in the fault memory of the ECM. Depending on the level of misfire rate measured the control unit will illuminate the "Service Engine Soon" light, may cut off fuel to the particular cylinder, and may switch lambda operation to open-loop. All misfire faults are weighted to determine if the misfire is emissions relevant or catalyst damaging.

OBDII Code P1360 Volkswagen - Ignition Circuit Cylinder 2 Short to Ground - AutoCodes.com
P1360 Volkswagen Code - Ignition Circuit Cylinder 2 Short to Ground

Need More Information on the Code?

Need more information on how to fix the P1360 Volkswagen code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1360 Volkswagen code diagnosed by a professional: Find a repair shop in your area

Code P1360 Volkswagen comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1360 Volkswagen code? Have you replaced any parts?
Any information is appreciated. Thanks