P1360 BMW - Misfire During Start Cylinder 10
- Faulty Spark Plug
- Faulty Ignition Coil
- Intake vacuum leak
- Faulty Camshaft Position Sensor
- Ignition Coil harness is open or shorted
- Ignition Coil circuit poor electrical connection
- Engine Light ON (or Service Engine Soon Warning Light)
P1360 Bmw DescriptionAs part of the CARB/OBD regulations, the Engine Control Module (ECM) must determine if a misfire is occurring and also identify the specific cylinder(s) and the severity of the misfire event and whether it is emissions relevant or catalyst damaging. In order to accomplish these tasks, the control module monitors the crankshaft for acceleration losses during firing segments of each cylinder based on firing order.
The misfire/engine roughness calculation is derived from the differences in the period duration (T) of individual increment gear segments. Each segment period consists of an angular range of 120° crank angle that starts 78° before Top Dead Center (TDC).
If the expected period duration is greater than the permissible value a misfire fault for the particular cylinder is stored in the fault memory of the ECM. Depending on the level of misfire rate measured the control unit will illuminate the Service Engine Soon light, may cutoff fuel to the particular cylinder and may switch lambda operation to open-loop. All misfire faults are weighted to determine if the misfire is emissions relevant or catalyst damaging.
Need more help?Get the P1360 Bmw code diagnosed by a professional: Find a repair shop in your area
P1360 BMW CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1360 Bmw code? Have you replaced any parts?
Any information is appreciated. Thanks