P1355 Buick Code - Ignition Control Module Output High/Pulse Detected When Grounded Cylinder 5
Quick Answer
The Ignition Control Module (ICM) has independent power and ground circuits. Common causes include Faulty Ignition Control Module, Ignition Control Module harness is open or shorted, Ignition Control Module circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P1355 Buick indicates Ignition Control Module Output High/Pulse Detected When Grounded Cylinder 5.
- Common causes
- Common causes include Faulty Ignition Control Module, Ignition Control Module harness is open or shorted, Ignition Control Module circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P1355 Buick Description
-The ignition control (IC) timing signal
-The IC timing control
-The low resolution engine speed signal
-The medium resolution engine signal
-The camshaft position signal
-The low reference
The ICM sends 3X signals to the PCM, and controls the timing advance during engine cranking. The timing advance changes to PCM control after the following actions occur:
The PCM receives the second 3X signal
The PCM applies 5 volts to the ignition control (IC) timing signal circuit.
The ICM monitors the CKP sync signal when the engine is cranking. The CKP sync signal is passed from the CKP sensor to the ICM on the CKP sensor 2 signal circuit. The CKP sync signal is used to determine the correct cylinder pair and initiate the ignition coil firing sequence. The 18X reference pulses are passed from the CKP sensor to the ICM on the CKP sensor 1 circuit. The 18X reference pulses are used for fuel injection and ignition control. After the ICM receives both signals, the ICM passes the 18X and 3X reference signals to the PCM. The CMP and the CKP sensors share a 12 volt reference and low reference circuit. The CKP sensor consists of the following circuits:
-A 12 volt reference
-A low reference
-A CKP sensor 1 signal
-A CKP sensor 2 signal
What are the Possible Causes of the DTC P1355 Buick?
- Faulty Ignition Control Module
- Ignition Control Module harness is open or shorted
- Ignition Control Module circuit poor electrical connection
How to Fix the DTC P1355 Buick?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P1355 Buick code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P1355 Buick code?
Need more information on how to fix the P1355 Buick code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P1355 Buick code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P1355 Buick Code
No Frequently Asked Questions about P1355 Buick Code found.
Discuss the causes and fixes for P1355 Buick OBDII Code
Code P1355 Buick comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
