AutoCodes - Ford - P1336 2000 FORD F150

P1336 2000 FORD F150 Code - Crankshaft Position Or Camshaft Position Sensor Input Signal Error

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P1336 2000 FORD F150 code possible causes

  • Faulty Crankshaft Position Sensor
  • Faulty Camshaft Position Sensor
  • Crankshaft Position Sensor harness is open or shorted
  • Crankshaft Position Sensor circuit poor electrical connection
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection

|How do I fix the P1336 2000 FORD F150 code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the P1336 2000 FORD F150 code

Labor: 1.0

The cost of diagnosing the P1336 2000 FORD F150 code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|What are P1336 2000 FORD F150 code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall
  • Engine difficult to start

|P1336 2000 FORD F150 code description

The Camshaft Position (CMP) sensor detects the position of the camshaft. The CMP sensor identifies when piston number 1 is on its compression stroke. A signal is then sent to the Powertrain Control Module (PCM) and used for synchronizing the sequential firing of the fuel injectors. Coil on plug (COP) ignition applications use the CMP signal to select the correct ignition coil to fire.
The Crankshaft Position (CKP) sensor is a magnetic transducer mounted on the engine block adjacent to a pulse wheel located on the crankshaft. By monitoring the crankshaft mounted pulse wheel, the CKP sensor is the primary sensor for ignition information to the PCM.
The PCM monitors the CKP sensor and the CMP sensor. The Diagnostic Trouble Code (DTC) sets when the PCM has detected a synchronization or erratic signal from the CKP sensor or the CMP sensors.
OBDII Code P1336 2000 Ford F150 - Crankshaft Position Or Camshaft Position Sensor Input Signal Error - AutoCodes.com

|Need more information with the P1336 2000 FORD F150 code?

Need more information on how to fix the P1336 2000 FORD F150 code? Get Access to Factory Service Manuals

|Need help with a P1336 2000 FORD F150 code?

Get the P1336 2000 Ford F150 code diagnosed by a professional: Find a repair shop in your area

|P1336 2000 FORD F150 code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1336 2000 Ford F150 code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?