AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P1336 1998 Ford F150

P1336 1998 Ford F150 Code - Crankshaft Position Or Camshaft Position Sensor Input Signal Error

- Code Popularity: 2,270 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1336 1998 Ford F150?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Crankshaft Position Sensor
  • Faulty Camshaft Position Sensor
  • Crankshaft Position Sensor harness is open or shorted
  • Crankshaft Position Sensor circuit poor electrical connection
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P1336 1998 Ford F150?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1336 1998 Ford F150 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1336 1998 Ford F150 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall
  • Engine difficult to start

Code P1336 1998 Ford F150 Description

The Camshaft Position (CMP) sensor detects the position of the camshaft. The CMP sensor identifies when piston number 1 is on its compression stroke. A signal is then sent to the Powertrain Control Module (PCM) and used for synchronizing the sequential firing of the fuel injectors. Coil on plug (COP) ignition applications use the CMP signal to select the correct ignition coil to fire.
The Crankshaft Position (CKP) sensor is a magnetic transducer mounted on the engine block adjacent to a pulse wheel located on the crankshaft. By monitoring the crankshaft mounted pulse wheel, the CKP sensor is the primary sensor for ignition information to the PCM.
The PCM monitors the CKP sensor and the CMP sensor. The Diagnostic Trouble Code (DTC) sets when the PCM has detected a synchronization or erratic signal from the CKP sensor or the CMP sensors.
OBDII Code P1336 1998 Ford F150 - Crankshaft Position Or Camshaft Position Sensor Input Signal Error - AutoCodes.com
P1336 1998 Ford F150 Code - Crankshaft Position Or Camshaft Position Sensor Input Signal Error

Need More Information on the Code?

Need more information on how to fix the P1336 1998 Ford F150 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1336 1998 Ford F150 code diagnosed by a professional: Find a repair shop in your area

Code P1336 1998 Ford F150 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1336 1998 Ford F150 code? Have you replaced any parts?
Any information is appreciated. Thanks