P1279 2005 NISSAN ALTIMA SEDAN - Air Fuel Ratio Sensor 1 Bank 1 Circuit Slow Response
- Faulty Air fuel ratio (A/F) Sensor 1 Bank 1
- Air fuel ratio (A/F) Sensor 1 Bank 1 Harness or connectors is open or shorted
- Air fuel ratio (A/F) Sensor 1 Bank 1 circuit poor electrical connection
- Fuel pressure
- Faulty Fuel injector
- Intake air leaks
- Exhaust Gas leaks
- Faulty PVC
- Faulty Air Flow Meter
When is the code detected?The response (from RICH to LEAN) of the A/F signal computed by ECM from A/F sensor 1 signal takes more than the specified time.
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible rough engine idle
P1279 2005 Nissan Altima Sedan DescriptionThe A/F sensor is a planar dual-cell limit current sensor. The sensor element of the A/F sensor is the combination of a Nernst concentration cell (sensor cell) with an oxygen-pump cell, which transports ions. It has a heater in the element.
The sensor is capable of precise measurement λ= 1, but also in the lean and rich range. Together with its control electronics, the sensor outputs a clear, continuous signal throughout a wide λ range (0.7 < λ < air).
The exhaust gas components diffuse through the diffusion gap at the electrode of the oxygen pump and Nernst concentration cell, where they are brought to thermodynamic balance.
An electronic circuit controls the pump current through the oxygen-pump cell so that the composition of the exhaust gas in the diffusion gap remains constant at λ = 1. Therefore, the A/F sensor is able to indicate air/fuel ratio by this pumping of current. In addition, a heater is integrated in the sensor to ensure the required operating temperature of 700 - 800 C (1,292 - 1,472 F).
Need more help?Get the P1279 2005 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area
P1279 2005 NISSAN ALTIMA SEDAN CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1279 2005 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks