AutoCodes - Nissan - P1226 2012 NISSAN ROGUE

P1226 2012 NISSAN ROGUE Code - Closed Throttle Position Learning Performance Problem

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P1226 2012 NISSAN ROGUE code possible causes

  • Faulty Electric throttle control actuator (TP sensor 2)
  • Electric throttle control actuator (TP sensor 2) harness is open or shorted
  • Electric throttle control actuator (TP sensor 2) circuit poor electrical connection

|How do I fix the P1226 2012 NISSAN ROGUE code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P1226 2012 NISSAN ROGUE code tech notes

Start by cleaning the throttle and adjust engine idle and erase engine code. If the code comes back you may have to replace the Electric Throttle Control Actuator (Motor) to repair the problem.

Nissan Rogue Idle Air Volume Relearn

|Cost of diagnosing the P1226 2012 NISSAN ROGUE code

Labor: 1.0

The cost of diagnosing the P1226 2012 NISSAN ROGUE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P1226 2012 NISSAN ROGUE code detected?

Closed throttle position learning is not performed successfully, repeatedly.

|What are P1226 2012 NISSAN ROGUE code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|P1226 2012 NISSAN ROGUE code description

Electric Throttle Control Actuator consists of throttle control motor, throttle position sensor, etc. The Throttle Position (TP) sensor responds to the throttle valve movement.
The throttle position sensor has the two sensors. These sensors are a kind of potentiometers which transform the throttle valve position into output voltage, and emit the voltage signal to the Engine Control Module (ECM). In addition, these sensors detect the opening and closing speed of the throttle valve and feed the voltage signals to the ECM. The ECM judges the current opening angle of the throttle valve from these signals and the ECM controls the throttle control motor to make the throttle valve opening angle properly in response to driving condition.
OBDII Code P1226 2012 Nissan Rogue - Closed Throttle Position Learning Performance Problem - AutoCodes.com

|Need more information with the P1226 2012 NISSAN ROGUE code?

Need more information on how to fix the P1226 2012 NISSAN ROGUE code? Get Access to Factory Service Manuals

|Need help with a P1226 2012 NISSAN ROGUE code?

Get the P1226 2012 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area

|P1226 2012 NISSAN ROGUE code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1226 2012 Nissan Rogue code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?