P11B3 2014 Chevrolet Silverado Code - HO2S Performance During Deceleration Fuel Cut-Off Bank 1 Sensor 2

The oxygen content of the exhaust is measured via the nitrogen oxide (NOx) sensors. The nitrogen oxides (NOx) sensors are part of the selective catalytic reduction system, a device used to reduce NOx emission on diesel engines. There are two NOx sensors, one placed upstream of selective catalytic reduction, to measure inlet NOx concentration, and one placed downstream. They are connected with the control module via CAN and all the information is exchanged through it. Since it is a smart sensor, all the electrical monitoring is performed inside the sensor and only the results are sent to the ECM. Each NOx sensor contains a sensing cell, a pumping cell, and a heater. A sample of exhaust gas passes through a diffusion gap between the sensing cell and the pumping cell. The NOx sensor maintains a constant reference voltage across the sensing cell. An electronic circuit within the sensor controls the pump current through the pumping cell in order to maintain a constant voltage in the sensing cell. The amount of current required to maintain the reference voltage in the sensing cell is proportional to the concentration of NOx in the exhaust. The ECM varies the amount of diesel exhaust fluid (reductant) added by varying the reductant injector duty cycle in response to changes in engine exhaust NOx levels. The smart NOx sensors consist of two components, the NOx module, and the NOx sensor element, that are serviced as a unit. A circuit or performance condition with a NOx sensor is detected by the NOx sensor module. The smart NOx sensor module communicates the condition to the ECM over the serial data line. The ECM sets a DTC when a serial data message is received from the NOx sensor module. The Diagnostic Trouble Code (DTC) will be set when the NOx sensor module detects a fault in the NOx sensor circuitry or a performance fault in the NOx sensor.

• Faulty Nitrogen Oxide (NOx) Sensor 2
• Nitrogen Oxide Sensor 2 harness is open or shorted
• Nitrogen Oxide Sensor 2 circuit poor electrical connection