AutoCodes - OBDII Code List - P1158 HONDA

P1158 HONDA - Air/Fuel Ratio Sensor 1 Terminal Low Voltage

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3    What is this?
Table of contents

P1158 HONDA Possible Causes

  • Faulty Air/Fuel Ratio Sensor 1
  • Air/Fuel Ratio Sensor 1 harness is open or shorted
  • Air/Fuel Ratio Sensor 1 circuit poor electrical connection

How do I fix code P1158 HONDA?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the P1158 HONDA code

Labor: 1.0

The cost of diagnosing the P1158 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

If the element is not activated or the Engine Control Module (ECM) terminal voltage is a set value or less for at least a set time period when the power is drawn to the A/F sensor (sensor 1) heater, a malfunction is detected and the code is stored.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1158 HONDA Description

The Air/Fuel Ratio (A/F) sensor 1 is installed in the exhaust system and detects oxygen content in the exhaust gas. The A/F sensor transmits output voltage to the Engine Control Module (ECM). A heater for the sensor element is embedded in the A/F sensor (sensor 1). It is activated and heats the sensor to stabilize and speed the detection of oxygen content by controlling current flowing through the heater. An increase in the current levels off as the applied voltage to the element electrode reaches a certain range because the amount of oxygen which is led through the diffusion layer is limited. The current amperage is proportional to oxygen content in the exhaust gas, so the air/fuel ratio is detected by the measurement of the current amperage. The ECM compares a set target air/fuel ratio with the detected air/fuel ratio and controls the fuel injection timing.
If the A/F sensor (sensor 1) voltage is low, the air/fuel ratio is lean, and the ECM uses A/F feedback control to issue a Rich command. If the A/F sensor (sensor 1) voltage is high, the air/fuel ratio is rich, and the ECM uses A/F feedback control to issue a Lean command.
OBDII Code P1158 Honda - Air/Fuel Ratio Sensor 1 Terminal Low Voltage - AutoCodes.com

More Information

Need more information on how to fix the P1158 HONDA code?
Get Access to Factory Service Manuals

Need more help?

Get the P1158 Honda code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1158 Honda code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧