AutoCodes – Chevrolet – P1153 2014 Chevrolet Silverado

P1153 2014 Chevrolet Silverado Code - HO2S Insufficient Switching Bank 2 Sensor 1

Quick Answer

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Common causes include Faulty Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1, Heated Oxygen Sensor Bank 2 Sensor 1 harness is open or shorted, Heated Oxygen Sensor Bank 2 Sensor 1 circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means
P1153 2014 Chevrolet Silverado indicates HO2S Insufficient Switching Bank 2 Sensor 1.
Common causes
Common causes include Faulty Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1, Heated Oxygen Sensor Bank 2 Sensor 1 harness is open or shorted, Heated Oxygen Sensor Bank 2 Sensor 1 circuit poor electrical connection.
Severity
High - diagnose this code as soon as possible.
Can I drive?
Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
AI answers can be wrong. Verify repairs with testing. Open full chat
Code Popularity 549
How popular is this code, among other codes? Low
Table of contents Created and updated by William Orellana on May 29, 2022
πŸ’¬ Need more help? Ask Coddy for instant answers β€” it's free!

Code P1153 2014 Chevrolet Silverado Description

The Heated Oxygen Sensors (HO2S) are used for fuel control and catalyst monitoring. Each HO2S compares the oxygen content of the surrounding air with the oxygen content of the exhaust stream. When the engine is started, the Engine Control Module (ECM) operates in an Open Loop mode, ignoring the HO2S signal voltage while calculating the air-to-fuel ratio. While the engine runs, the HO2S heats up and begins to generate a voltage within a range of 0 - 1, 000 mV. Once sufficient HO2S voltage fluctuation is observed by the ECM, Closed Loop is entered. The ECM uses the HO2S voltage to determine the air-to-fuel ratio. An HO2S voltage that increases toward 1, 000 mV indicates a rich fuel mixture. An HO2S voltage that decreases toward 0 mV indicates a lean fuel mixture.
The heating elements inside each HO2S heat the sensor to bring the sensor up to operating conditions faster. This allows the system to enter Closed Loop earlier and the ECM to calculate the air-to-fuel ratio sooner.
The Diagnostic Trouble Code (DTC) will be set when the ECM detects that the heated oxygen sensor rich-to-lean counts or the lean-to-rich counts are less than a calibrated value greater than 100s.
OBDII Code P1153 2014 Chevrolet Silverado - HO2S Insufficient Switching Bank 2 Sensor 1 - AutoCodes.com
P1153 2014 Chevrolet Silverado Code - HO2S Insufficient Switching Bank 2 Sensor 1

What are the Possible Causes of the DTC P1153 2014 Chevrolet Silverado?

  • Faulty Heated Oxygen Sensor (HO2S) Bank 2 Sensor 1
  • Heated Oxygen Sensor Bank 2 Sensor 1 harness is open or shorted
  • Heated Oxygen Sensor Bank 2 Sensor 1 circuit poor electrical connection
  • Low or high fuel system pressure
  • Fuel contamination
  • Faulty fuel injectors
  • Exhaust gas leaks
  • Engine vacuum leaks

How to Fix the DTC P1153 2014 Chevrolet Silverado?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1153 2014 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P1153 2014 Chevrolet Silverado code?

Need more information on how to fix the P1153 2014 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1153 2014 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P1153 2014 Chevrolet Silverado Code

No Frequently Asked Questions about P1153 2014 Chevrolet Silverado Code found.

Discuss the causes and fixes for P1153 2014 Chevrolet Silverado OBDII Code

Code P1153 2014 Chevrolet Silverado comments

No comments found for this page.

AutoCodes App

Fix Your Car Smarter

Try the New AutoCodes App!

Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.

AutoCodes App on Google Play